l already have the door panel off... do l need to use epoxy remover, or will there be bolts? Will l need special tools? Is this an easy job? How long does it take?
Thank you for your time.
the window is on the passenger front. will l need a special technique or move?

its not that easy of a job if you have never done it before,if your just replacing a glass you can unbolt it,from the regulator on it,unless you know how to do it,,you,ll need a repair manual to help you with on this one because theres one certain way that glass will come out through the opening,good luck.

It is usually not that hard. l have not worked on a '96 Intrepid, but the other cars l worked on were easy enough. You lower the window down until u can reach the bolts or clips that fasten the glass to the regulator. Remove the fasteners, push the power window button to lower the regulator down out of the way , then ease the glass out through the window opening. l usually tip the front edge of the glass down further into the door, & work the wider end out first. If the window regulator or motor is broken, then u will have take out the regulator first. Just be careful not to let the glass fall down into the door & break it.