Ok so l posted about my clutch going out and it not even grinding trying to put it into a gear without the clutch being pushed in. Well new information. Today l started it and it went into gear and engaged and l drove it just fine. l had to tow it home 2 days ago because it wouldnt catch any gears not even reverse. Any other insight into this problem? Background info is l put a new clutch in 1 week ago and the day l had to tow it l was in 4th and it just wouldnt catch the gear and rolled to a stop. Once it stopped it wouldnt go into any gear, l could put it into all gears without pushing the clutch in, and once in gear if l did use the clutch and l let off it wouldnt stall, it would just idle. So any other info please send me a message or anything. Email me l dont care, just trying to figure out what exactly is wrong with my car.
the clutch cannot possibly have gone out in less than 1 week with normal driving.

bad slave cylinder?

Your clutch is gone. Get a new one.

its possible there too much pressure on the slave cylinder & when u use it its not letting the clutch engage, then when u let it set the pressure dies off & it works until u use it again,i have seen that happen on one before but man its really rare when u see one do that,if that is the case though its a slave cylinder or a master cylinder causing this too happen,the transmission wont come & go like that it will either be good or bad,the only other possibility is a broken shift fork in the transmission,that might be causing some of ur problems,good luck.